Weidmuller PTX800A Bedienungsanleitung Seite 35

SetupSequence(continued)
Totalandratedisplaysettingsandscaling
Rate decimal
tot_dp=
point
rate_SEC
rate_min
Rate timebase
rate_Hr
rATe_day
rAtELO=
Rate Range
rAtEHI=
rateCut=
Cut-out rate
Show rate or
dis=rate
total
dis=tot
Total decimal
tot_dp=
point
Total scaling
tot_sf=
factor
Resetkeyenable
Reset Total Key
En_resY
Enable
En_resn
Alarmenable
Alarms 1 & 2
Select
Alarmchannelonesettings
Coil energisa-
A1_nor_E
tion
A1_nor_d
A1=_rate
Alarm one type
A1=_tot_
Alarm one
A1=_LO
action
A1=_HI
Set_Pt1=
Setpoint value
Deadband
dband_1=
value
delay_1=
Timer delay
Introduces rate decimal point
Demo, e.g., rate shown to 3 decimal places
12. 3 45
Rate is in units per second
Rate is in units per minute
Rate is in units per hour
Introduces rate low value
Value, e.g., 0.00 %
0. 0 0
Introduces Input high value
Value, e.g., 100.00 %
100. 0 0
Introduces the low cut-out rate
Value, e.g., 1.00 %
1. 0 0
Display normally shows the rate
Display normally shows the total
Introduces total decimal point
Demo, e.g., total shown to one decimal place
1234. 5
Introduces total scaling factor
Value, e.g.,total units = rate units
1
RESET key resets count
RESET key ignored
Enable
AL=Yes
Disable (Select this option for PMX420)
AL=NO
Normally energised
Normally de-energised
Channel one monitors rate
Channel one monitors total
Low type (active below setpoint)
High type (active above setpoint)
Setpoint value
e.g., 50.00 %
50. 0 0
Deadband value
e.g., 0.01 %
0. 0 1
Timer delay (set to 0 s to disable)
e.g., 20 s
20
- - Next
Shift Shift Accept
Toggle Accept
- - Next
Dec Inc Accept
- - Next
Dec Inc Accept
- - Next
Dec Inc Accept
Toggle Accept
- - Next
Shift Shift Accept
- - Next
x0.1 x10 Accept
Toggle Accept
Toggle Accept
Toggle Accept
Toggle Accept
Toggle Accept
- - Next
Dec Inc Accept
- - Next
Dec Inc Accept
- - Next
Dec Inc Accept
5