Weidmuller PTX800A Bedienungsanleitung Seite 42

Procedure
Whenthe
Action/Description
displayshows
Put the instrument in setup mode and scroll through the main menu
CALIn_n Press ì or Å
Press PGM to select Input calibration
CAlIn_y
Connect the multimeter to measure the Input level, then press PGM
InP_LO_=
Set the Input signal to the appropriate value, e.g., 4.00 mA
4. 0 0
When you are happy that the Input is correct, press PGM
After approx 5s the display introduces the next calibration point. Press PGM
Inp_HI_=
Set the Input signal to the appropriate value, e.g., 20.00 mA
20. 0 0
When you are happy that the Input is correct, press PGM
Continue with the setup sequence.
dFactor=
Note: Do not remove the power while the save message is on display.
Link both pairs
of posts for
voltage outputs
PTX800 analogue output board showing output type jumper locations.
4