Charging The Built-In Battery; Rear Panel Description - Party Light & Sound PARTY-215LED-MKII Bedienungsanleitung

EN
ance. Do not obstruct the air circulation with objects such as magazines, table cloths or curtains. This prevents
the dissipation of heat from the appliance and can result in overheating.
⠗ Only use the appliance in a moderate climate, not in tropical environments.
⠗ All persons involved in operating, installing and servicing the appliance and putting it into service must be
trained and qualified accordingly and observe these operating instructions.
⠗ Defective mains cables may only be replaced by specialists. Danger of shock hazard!
Disconnection from the mains
⠗ Where the MAINS plug or an appliance couples is used as the disconnect device, the disconnect device shall
remain readily accessible.
⠗ If a switch is used to disconnect the device, the switch and its function must be clearly identified and remain
easily accessible.
IMPORTANT NOTE ON LEAD-ACID BATTERIES
1. PRIOR to using the unit for the first time, please charge fully the battery without any interrup-
tion.
2. Charge the battery regularly after each use. Don't wait until it is discharged!
3. DON'T allow the battery to discharge completely! Once the battery is fully discharged, the current
drain for recharging will be so high that it will damage the charger and/or the power supply of the unit.
4. If you don't use the unit for a longer period of time, please CHARGE THE BATTERY COMPLETELY AT
100% and check/charge it once per month otherwise the battery will be out of use.
The life time of the battery depends on the observance of these recommendations.
We cannot be held responsible for damaged batteries further to the non-observance of these basic

Charging the built-in battery

Plug the supplied mains lead into AC socket (9) and the other end into a suitable wall outlet. The charge indica-
tor (19) starts flashing to show that the built-in battery has started charging. Once the battery is fully charged,
the indicator stops flashing.

Rear panel description

1. SD card input
2. USB stick input
3. Master volume control
4. TREBLE control: Adjustment of high frequencies
5. BASS control: Adjustment of low frequencies
6. Echo control for the microphone
7. Microphone volume control
8. Guitar volume control
9. AC input connector
10. ON/OFF switch of the system
11. FM antenna
12. Switches the LED on the woofer on /off
13. AUX input via RCA connectors
14. Input connector for a guitar or a microphone
15. Input selector: Press the MODE button to switch between the various inputs
(LINE, USB, SD, BT, FM)
16. In USB/SD /Bluetooth mode: press to go back to the previous track. In FM mode:
press to go to the previously stored FM station.
17. Play/pause in USB/SD /Bluetooth mode. In FM mode, press and hold this button
to start searching for radio stations and store them automatically in the memory
18. In USB/SD Bluetooth mode: press to go to the next track. In FM mode: press to
go to the next stored FM station.
19. Charge indicator: Switch on to start charging. Lights up when it is charging and
stops twinkling when the battery is fully charged.
** BATTERIES ARE NOT COVERED BY THE WARRANTY **
rules.
19
   
16 17 15 18
100-240V~
50/60Hz
3