Bosch GDR 160-LI Betriebsanleitung Seite 15

(14) Cover cap
Technical Data
Cordless impact screwdriver
Article number
Rated voltage
A)
No-load speed
Impact rate
Maximum torque, hard screwdriving application according to ISO 5393
A)
– ¼" internal hexagon
– ■ ½"
Machine screw diameter
Tool holder
Weight according to EPTA-Procedure 01:2014
Recommended ambient temperature during charging
Permitted ambient temperature during operation
during storage
Recommended batteries
Recommended chargers
A) Depends on battery in use
B) Limited performance at temperatures <0 °C
Noise/Vibration Information
Noise emission values determined according to
EN 62841-2-2.
Typically the A-weighted noise level of the power tool is:
Sound pressure level 96 dB(A); sound power level
107 dB(A). Uncertainty K = 3 dB.
Wear hearing protection
Total vibration values a (triax vector sum) and uncertainty K
h
determined according to EN 62841-2-2:
Tightening screws and nuts of the maximum permitted size:
2 2
a = 9.5 m/s , K = 1.5 m/s .
h
The vibration level and noise emission value given in these
instructions have been measured in accordance with a
standardised measuring procedure and may be used to com-
pare power tools. They may also be used for a preliminary
estimation of vibration and noise emissions.
The stated vibration level and noise emission value repres-
ent the main applications of the power tool. However, if the
power tool is used for other applications, with different ap-
plication tools or is poorly maintained, the vibration level
and noise emission value may differ. This may significantly
increase the vibration and noise emissions over the total
working period.
Bosch Power Tools
A) Accessories shown or described are not included with the
product as standard. You can find the complete selection of
accessories in our accessories range.
V
-1
min
-1
min
Nm
Nm
mm
¼" internal hexagon
A)
kg
°C
B)
and °C
To estimate vibration and noise emissions accurately, the
times when the tool is switched off or when it is running but
not actually being used should also be taken into account.
This may significantly reduce vibration and noise emissions
over the total working period.
Implement additional safety measures to protect the oper-
ator from the effects of vibration, such as servicing the
power tool and application tools, keeping their hands warm,
and organising workflows correctly.
Assembly
Remove the battery from the power tool before carry-
u
ing out work on the power tool (e.g. maintenance,
changing tool, etc.). The battery should also be re-
moved for transport and storage. There is risk of injury
from unintentionally pressing the on/off switch.
Charging the Battery
Use only the chargers listed in the technical data. Only
u
these chargers are matched to the lithium-ion battery of
your power tool.
Note: The battery is supplied partially charged. To ensure
full battery capacity, fully charge the battery in the charger
before using your power tool for the first time.
English | 15
GDR 180-LI GDX 180-LI
3 601 JG5 1.. 3 601 JG5 2..
18
0–2800
0–3600
160
–
M6–M14
¼" internal hexagon
1.7
0 to +35
-20 to +50
GBA 18V... GBA 18V...
ProCORE18V... ProCORE18V...
GAL 18...
GAX 18...
GAL 36...
1 609 92A 5XY | (22.07.2020)
18
0–2800
0–3600
160
180
M6–M16
■ ½"
1.8
0 to +35
-20 to +50
GAL 18...
GAX 18...
GAL 36...