Connecting The M-Net Interface, The Power Supply, And The Me Remote Controller - Mitsubishi Electric MAC-399IF-E Installationshandbuch

6. Connecting the M-NET Interface, the Power Supply, and the ME Remote Controller

• When connecting the unit to a system controller or ME Remote Controller, connect the transmission line of the M-NET to the
control signal terminal.
Connect the 2-core connection wrings A to A1/B1 or A2/B2 (they can be connected to either).
• Cross the shield portion of each connecting wire using the S terminal only when cross wiring the connection wires.
• When connecting the connection wrings A and the ME Remote Controller connection wrings B to the terminal board, there is
no need to worry about polarity.
When the connection wrings A are not cross-wired
2
• After the wiring is completed secure the ires with the cord clamp (large) and the cable ties.
When the connection wring A is not cross-wired
1
1 Screws
2 Cord clamp (large)
3 Cord clamp (small)
Caution
• Electrical work should be performed in accordance with the Technical Standards Regarding Electrical Equipment
and the Interior Wiring Standards.
• Connection wiring and remote control wiring should be located as far away from other electrical wiring as possible.
Placing them too closely together could cause a malfunction.
Downloaded from www.Manualslib.com
A1 B1 A2 B2 S
3
2
4
4 Cable ties
5 Cut with nippers at the notches.
Make sure the cut surface is free of any burr so that the
connection wire dose not get damaged.
manuals search engine
When the connection wrings A are cross-wired
A1 B1 A2 B2
2
3
When the connection wring A is cross-wired
1
4
5
1 Shield
2 Connection wirings A
(M-NET transmission wire)
3 ME Remote Controller
(only when needed)
S
1
2
Bare wire size
When using the ME remote controller
3
2
1
1
4
4
2
7