Installing The Appliance; Connecting The Appliance - Inventum IMC6035RT Benutzerhandbuch

Note:
Make sure that the kitchen furniture is prepared according to the dimensions of the appliance.

INSTALLING THE APPLIANCE

Preliminary requirements
1. Make sure that the kitchen furniture is prepared according to the correct dimensions.
Warning:
Two persons are required to install the appliance.
Caution:
Make sure that the mains cable does not get jammed during installation or is placed on top of the
appliance.
Caution:
Do not cover the opening between the kitchen furniture and the top of the appliance. The opening is
required for ventilation.
Note:
It is possible to connect the appliance to the mains supply before positioning the appliance.
Procedure
1. Put the appliance (A) in the center of the kitchen furniture.
Caution:
Make sure that there is a minimum space of 2 mm between the appliance and the walls of the kitchen
furniture.
2. Open the door (E) of the appliance.
3. Place the appliance in the kitchen furniture.
4. Install the plugs (B).
5. Fasten the appliance to the kitchen furniture. Use the screws (D).
6. Install the covers (C).
7. Close the door.
8. Connect the appliance. Refer to section

CONNECTING THE APPLIANCE

1. Make sure that the voltage in your home corresponds with the voltage of the appliance.
2. Make sure that the electrical system in your home is supplied with a 16 Amp fuse.
Note:
If you replace the supplied mains cable, make sure that the new mains cable has a minimum core
cross section of 2.5 mm2 and a length of 1.5 m. If you use a mains cable that is too short, you cannot
connect the appliance and position it in the kitchen furniture before connecting the appliance to the
mains socket.
3. Use the supplied mains cable to connect the appliance to the mains socket.
After connecting, the clock shows '00:00' and you will hear a sound signal.
36 • English
'Connecting the appliance'
.
(Figure 4)