Herunterladen Inhalt Inhalt Diese Seite drucken

Operation; Power Supply - AEG DVD 4553 LCD Bedienungsanleitung

Dvd car cinema
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

English
40
Insert Batteries into the Remote
Control/replace
A. Alternating Current Adapter

Operation

WARNING:
Leaking battery acid may cause a health hazard. Remove batteries from
the remote control when depleted or the unit is not in use for an ex-
tended period of time. Clean up any leakage with a cloth immediately.
In the event of skin contact, rinse the afected area immediately. In case
of ingestion consult a physician immediately. In the event of eye contact,
rinse eyes and consult a physician immediately.
CAUTION:
Upon disposal, adhere to the recycle and environmental regulations of
your respective country. Never throw batteries into open fire.
NOTE:
The life span of enclosed batteries may be reduced due to storage.
1. Open the battery compartment on the bottom of the remote control.
2. Insert two batteries of the "AAA", "R03" type. Pay attention to the
polarity.
3. Close the battery compartment again.
NOTE:
The signals of the remote control are transmitted to the DVD-Player
by infrared light. Ensure that the DVD-Player is not exposed to direct
sunlight. This may render the signal transmittal from the remote control
to the DVD-Player impossible.
Remote Control Range
To use the remote control point it toward the remote control sensor
located at the front of the unit. The distance between remote control
and sensor should not exceed 5 meters. The angle of the remote control
to the sensor should not exceed 30 degrees within right, left, above and
below.

Power Supply

The alternating current adapter is functional with an alternating current of
100 V and 240 V but:
K
The enclosed mains cable may only be connected to a power source
of 230-240 V alternating current within Europe.
K
To connect to an alternating current source outside of Europe a plug
adapter compatible with the respective outlet must be used.
1. Connect the AC adapter cable to the DC IN connector
(Fig. 1/2) of the device.
2. Connect the AC adapter to a properly installed Schuko socket. The
charging indicator will lights red (Fig. 1/15).

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis