Technical Specifications - Weelko MOVE Bedienungsanleitung

INSTRUCTIONS
8. The probe and equipment must be
kept cleaned and disinfected with alco-
hol after using it.
9. Use continuous wave to clean the skin
and remove dirt and the discontinuity
wave to perform massage or remove
wrinkles.
10. The equipment will automatically get
turned off after using it for 10 minutes.
11. Charge the equipment for one
hour each time.

TECHNICAL SPECIFICATIONS

INPUT
AC 100-240V 50/60Hz
OUTPUT
DC 5V 1A
POWER
3W
EN
WARNINGS & REMARKS
•Do not use the equipment around the
eyes and wounds.
•Keep the machine out of the reach of
children.
•Do not apply this treatment with preg-
nant women.
•The device can produce a squeak sound
when it is being used close to an audio
frequency.
•Please do not extend the power cord or
use additional plugs.
•Please pull out the plug when it is not
used. Avoid long-time using to avoid sur-
charging the equipment.
•Please do not damage, manipulate or
pull the power cord off by force and avoid
the power cord tangled on the equipment
because it may cause fire or short circuit.
If the power cord is damaged or gets hot,
please stop operation immediately.
• Please do not use the equipment with
wet hands.
• Please do not use any solvent or similar
to clean the equipment as it can damage
it.
• Do not use the equipment in a tem-
perature below 0 degrees or above 40
degrees and do not expose it to direct
sunlight.
© 2020 Weelko
www.weelko.com
Importer: Weelko Barcelona, S.L.
ESB65397556