Weelko MOVE Bedienungsanleitung Seite 10

Nasal bridge cleaning care
Forehand and lower jaw cleaning care
Eye bags and wrinkles cleaning care
EN
INSTRUCTIONS
1. In order to disinfect and protect the
skin, clean and pat around the whole face
with a suitable astringent lotion and wait
until it is absorbed.
2. Apply toner on the skin, then press the
ON/OFF switch so as to start the opera-
tion.
3. Press the sonic wave switch to select
the ultrasonic mode. The pressing se-
quence is:
Continuous wave level 2 >Level 3 > Dis-
continuity wave level 1 > level 2 > level 3 >
continuous wave level 1.
4. Press the ion switch to select microcu-
rrent mode. The pressing sequence is:
Clean+ level 2>level3 >Nutri- level1>le-
vel 2>level 3>EMS level 1>level2>level
3>Clean+ level1.
5. This equipment consists of 3 func-
tions: 1. Cleansing, 2. Nutrition, 3. Wrinkle
removing. Select the wave and the ion
mode according to your needs.
6. Place the shovel-type probe into con-
tact with the skin to start atomising the
sebum of the pores. By slowly moving the
probe around the surface to be cleaned,
you will start removing blackhead, pim-
ples and acne.
tes.
7. The function must be chosen according
to the skin care products used (clean-
sing remover gel or toner). The treatment
should not exceed the 10 minutes each
time.
© 2020 Weelko
www.weelko.com
Importer: Weelko Barcelona, S.L.
ESB65397556