Operation; Technical Specifications - Weelko FINEX Bedienungsanleitung

OPERATION

1. To switch the equipment on, press
the button "Power".
2. The first time you use the equip-
ment, the clock needs to be adjusted on
time. To do so, press the button "7" and
the first two numbers of the clock will
shine. Then, by pressing the buttons "5"
and "8", you will be able to adjust the
hour. If you press the button "7" again,
the last two numbers of the clock will
shine. Then, press the buttons "5" and "8"
to adjust the minutes. To complete the
clock setting, press the button "7" again.
3. To adjust the working mode, press
the "2" button. Then, the "Auto on" and
"Auto off" indicator will shine. If you
press the "4" button, the numbers of the
display will shine and you will be able to
adjust the time at which the automatic
mode has to be switched on by pressing
the "5" and "8" buttons. If you press the
"3" button, you will be able to set the
time at which the automatic mode has
to be switched off. If the indicators ("12"
and "13") do not shine, it means that the
machine is working in the manual mode.
4. Temperature unit setting. Press
the "11" button to select the temperature
unit. Then, the "5" and "8" will allow you
to choose either the Fahrenheit (F) or the
Celsius (C) scale.
5. Target temperature setting. Press
the "9" button to set the target tempe-
rature. The "5" and "8" buttons will allow
you to reach the temperature needed.
6. Current temperature display. Press
the "10" button to see the current tempe-
rature.
REMARKS
EN
• After turning on the automatic mode,
do not unplug the equipment. Make sure
that the clock is on time.
• If the automatic mode is not used,
make sure that you switch the equip-
ment off after use.
• The machine can save the temperature
that was set last time.
• Before starting the treatment, check
the temperature on your hand to see if
it is the proper one and make sure it will
not be uncomfortable for the customer.
• If the skin is damaged, do not apply
this treatment.
• After finishing the treatment, do not
pour the remaining paraffin when it is
still liquid. Turn off the unit and wait for
the paraffin to get colder and become
completely solid. Then, turn the equip-
ment on again and wait for the paraffin
at the bottom to be melted and you will
be able to remove the paraffin block
easily.
• In order to shorten the melting time,
choose the maximum temperature. Once
the paraffin is completely melted, then
adjust the temperature at the proper
one.
• If the power cord is damaged, it should
be replaced by one provided by the ma-
nufacturer or the authorised technical
service.

TECHNICAL SPECIFICATIONS

MELTING TIME
TEMPERATURE RANGE
CAPACITY
RATED POWER
RATED VOLTAGE
30 minutes
46 - 60º
5000 ml
200W
AC 220V ~ 240V