EN
U S I N G YO U R 2 - I N - 1 H U M I D I F I E R & D I F F U S E R
Note:
•
If there is no water in the tank, the
humidifier will not turn on and
blink. Fill the water tank (see
Started, page 5).
•
Keep the humidifier stable while using, or
water may spill.
Mist Level
Press
1.
on the low mist level.
2.
Press
mist levels (low, medium, high) and to
turn the humidifier off.
Intelligent Sleep Mode
Intelligent Sleep Mode turns off all display
lights and uses a humidity sensor to
automatically adjust the mist level to
maintain a 60% relative humidity (RH) while
you sleep.
1.
Press
Note: The humidifier must be on to start
Sleep Mode.
Press
2.
seconds, all display lights will turn off.
Press
3.
to cancel Sleep Mode. The humidifier
will go back to the previously set mist
level.
Note:
•
Excessive humidity can cause health
issues and mould growth. If the
relative humidity in your room is over
60%, use the low mist setting or turn
off the humidifier.
8
Getting
once. The humidifier will start
several times to cycle through
to turn on the humidifier.
to start Sleep Mode. After 5
a second time (or press
Water Level
will
Your humidifier must have the correct level
of water in the base to work properly. If there
is too much water in the base, the humidifier
cannot create mist.
Never
•
Only
[Figure
release the correct amount of water into
the base.
•
Do not
especially while it is running. This may
cause the water tank to release too much
water into the base.
When you move the humidifier, follow these
•
steps to avoid accidentally releasing too
much water into the base.
1.
2.
3.
4.
5.
6.
If your humidifier doesn't produce mist
•
correctly, check the max water line to see if
there is too much water in the base.
Note: The max water line is only for this
)
purpose. Do not pour water into the base.
pour water directly into the base.
add water to the water tank.
2.1] The humidifier will automatically
move or shake the humidifier,
Turn off and unplug the humidifier.
Lift the tank off the base.
Pour any water out of the base.
Move the tank and base
to the new location.
Place the tank securely back on the
base.
Plug in the humidifier and turn it on.
Figure 2.1
separately