Berner BACSS-18V Bedienungsanleitung/Sicherheitshinweise Seite 16

Safety instructions
When using power tools, always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and
personal injury.
Read all of this manual carefully before
operating the tool.
Save this manual for future reference.
General
1 Keep work area clean
Cluttered areas and benches can cause accidents.
2 Consider work area environment
Do not expose the tool to rain. Do not use the
tool in damp or wet conditions. Keep the work
area well lit (250 - 300 Lux). Do not use the tool
where there is a risk of causing fire or
explosion, e.g. in the presence of flammable
liquids and gases.
3 Keep children away
Do not allow children, visitors or animals to
come near the work area or to touch the tool or
the mains cable.
4 Dress properly
Do not wear loose clothing or jewellery, as
these can be caught in moving parts. Wear
protective hair covering to keep long hair out of
the way. When working outdoors, preferably
wear suitable gloves and non-slip footwear.
5 Personal protection
Always use safety glasses. Use a face or dust
mask whenever the operations may produce
dust or flying particles. If these particles might
be considerably hot, also wear a heat-resistant
apron. Wear ear protection at all times. Wear a
safety helmet at all times.
6 Do not overreach
Keep proper footing and balance at all times.
7 Stay alert
Watch what you are doing. Use common sense.
Do not operate the tool when you are tired.
8 Secure workpiece
Use clamps or a vice to hold the workpiece. It is
safer and it frees both hands to operate the tool.
9 Connect dust extraction equipment
If devices are provided for the connection of
dust extraction and collection facilities, ensure
that these are connected and properly used.
10 Remove adjusting keys and wrenches
Always check that adjusting keys and
wrenches are removed from the tool before
operating the tool.
11 Use appropriate tool
The intended use is described in this instruction
manual. Do not force small tools or attachments
to do the job of a heavy-duty tool. The tool will
do the job better and safer at the rate for which
it was intended. Do not force the tool.
Warning! The use of any accessory or
attachment or performance of any operation
with this tool other than those recommended in
this instruction manual may present a risk of
personal injury.
12 Check for damaged parts
Before use, carefully check the tool and mains
cable for damage. Check for misalignment and
seizure of moving parts, breakage of parts,
damage to guards and switches and any other
conditions that may affect its operation.
Ensure that the tool will operate properly and
perform its intended function. Do not use the
tool if any part is damaged or defective. Do not
use the tool if the switch does not turn it on and
off. Have any damaged or defective parts
replaced by an authorised BERNER repair
agent.
Never attempt any repairs yourself.
13 Remove the battery pack
Switch off and wait for the tool to come to a
complete standstill before leaving it unattended.
Remove the battery pack when not in use,
before changing any parts of the tools,
accessories or attachments and before servicing.
14 Avoid unintentional starting
Do not carry the tool with a finger on the
switch. Be sure that the tool is switched off
before inserting the battery pack.
15 Store idle tools
When not in use, tools must be stored in a dry
place and locked up securely, out of reach of
children.
16 Maintain tools with care
Keep the tools in good condition and clean for
better and safer performance. Follow the
instructions for maintenance and changing
accessories. Keep all handles and switches
dry, clean and free from oil and grease.
E N G L I S H
15