EN
RESULT
The tool is clamped onto the machine spindle or adapter with
the correct tightening torque.
34
Inserting the tool
Clamping tool
INFORMATION
When putting on the tool,
make sure that the face con-
nection of the machine spin-
dle or the adapters and the
HSK interface of the tool lie
plane and that the tool key-
ways are meshed.
10. Insert the tool together with
the appropriate interface into the
machine spindle or adapter.
11. Tighten the threaded spin-
dle/clamping screw clockwise
with the torque wrench using the
defined tightening torque (see
section 4.4 Technical data).
Montage- und Betriebsanleitung
Installation and Operating Instructions