INSIDO 89980104 Bedienungsanleitung Seite 13

89980104
USE AND FUNCTION
Assembling vacuum cleaner
Note:
Always remove the power plug from the wall outlet before assembling or removing accessories.
1. Attaching the Flexible Hose into the vacuum cleaner. Align the rim and insert the flexible hose into the air
inlet socket.
2. Fitting the tube to the curved wand/hose extension. Push the tube into the curved wand/hose extension.
3. Fitting the floor brush to the tube. Push the tube into the floor brush. Adjust the tube to the desired length.
Tip: By reducing the suction power you can move the floor brush easier on the floor. Set the suction power
to minimal for furniture, to medium for carpet and hard floors. Only use the maximum setting on hard floors
in combination with a brush for hard floors.
BUTTON FUNCTION INTRODUCTION
Note:
Once all attachments are in place, unwind a sufficient length of cable and insert the plug into the wall outlet. A
yellow mark on the power cord shows the ideal cable length. Do not pull the power cord beyond the red mark.
1. Insert the power plug into the wall outlet.
2. Press the on/off button located on the unit to turn the vacuum cleaner "on". To adjust the suction, slide the
speed control button to control the suction power of the vacuum cleaner.
3. To rewind the power cord, press the cord rewind button with one hand and guide the power cord with the
other hand to ensure that it does not whip causing damage or injury.
Cord rewind button
Dust cup release button
On/off button
- 12 -
Handle
Speed control button
Power cord & plug
EN