Device Description - Sika induQ VMI Serie Betriebsanleitung

Device description

2 Device description
The of the VMI series from SIKA is a flow sensor without moving parts. The meas-
urement is performed using magnetic induction.
The VMI is used for measuring or metering water and electrically conductive fluids. The com-
pact design and independence from the intake and discharge sections allows the VMI to be
used under a variety of conditions.
Versions
The VMI is available in nominal sizes DN 2, DN 7, DN 10 and DN 20.
Type plate
The type plate sticker is located on the bottom side of the VMI.
It contains the most important data, the connection diagram and the arrow for the flow direc-
tion.
Unpacking
 Carefully unpack the unit to prevent any damage.
 Check the completeness of the delivery based on the delivery note.
Scope of delivery
 1x VMI as ordered.
 1x Operating manual.
WICHTIG
 Use the type plate to check if the delivered unit corresponds to your order.
 In particular, for devices with electrical components, check to see if the correct
power supply voltage is specified.
Accessories
 Connection cable with moulded M12x1 coupling
socket.
 M12x1 coupling socket for self-assembly.
- 26 -
— Series VMI
© SIKA • Ba_VMI • 10/2020