Getting Started - SimonsVoss SmartCD2.G2 Kurzanleitung

SmartCD2.G2
NOTE
SmartCD2.G2 coupling on the Smartphone
If you use the SmartCD2.G2 with a Smartphone via Bluetooth, the con-
nection cable from the SmartCD2.G2 to the PC/laptop must be un-
plugged again. It is not possible to use Bluetooth to communicate
between SmartCD.G2 and a PC or laptop.
USB and Bluetooth cannot be used simultaneously
You must ensure that the Bluetooth connection is not active before connecting
SmartCD2.G2 to the USB port. The Bluetooth function switches off automatically after
15 minutes. It can also be switched off manually by pressing a button on the program-
ming device. If this not the case, communication cannot be established via the USB port.
Transponders can only be programmed if the SmartCD2.G2 is
connected directly (via USB cable) to a PC/tablet/laptop and the LSM
software is installed.

6 Getting started

1. Install the LSM software.
2. Connect the programming device to a USB port (see
9
If you want to use the programming device with a smartphone, follow
the instructions in the app or the manual for the app.
EN
9 Required drivers are installed automatically.
}
[ 24]
).
The programming device is ready for use.
6. Getting started
Connecting
25 / 112