Preparing The Place Of Installation; General Considerations; Safety Precautions; Place Of Installation - Palazzetti TWIGGY Installations- Und Wartungsanleitungen

5 PREPARING THE PLACE
OF INSTALLATION
5.1

General considerations

In the following paragraphs there are some
indications to be respected in order to obtain
the maximum performance of the purchased
product and its safe operation. The following
indications are however subject to compliance
with any possible national, regional and munic-
ipal laws and regulations in force in the country
where the appliance is installed.
For Italy, the installation must be carried out by
a qualified person in compliance with the EN
10683 standard.

5.2 Safety Precautions

The operations for assembly and disassembly of
the appliance are reserved for specialist techni-
cians only.
It is recommended to be sure of their qualifica-
tions and their actual capacity.
For Italy, these technicians must be in
possession of the letter "C" qualifica-
tion issued by the chamber of com-
merce based on the Ministerial Decree.
37/08.
The person in charge of the installation, before
starting assembling or disassembling the ma-
chine, must comply with the safety precautions
required by law and in particular with the below:
• the person must not operate in adverse work-
ing conditions;
• the installer must operate in perfect psycho-
physical conditions and must check that the
personal protective equipment is intact and
functioning perfectly;
• they must wear gloves and safety shoes;
• they must make sure that the area used during
assembly and dismantling is free from obsta-
cles.

5.3 Place of installation

For the minimum distances that must be respect-
ed when positioning the appliance with respect
to flammable materials and objects, refer to the
Product booklet delivered as an attachment with
the appliance.
Floors made of flammable material such as wood,
parquet, linoleum, laminate or floors covered
with carpets must be protected by a fireproof
base under the appliance that also protects the
004771070 - 17/11/2020
ITALIANO ENGLISH DEUTSCH
front during cleaning from any falling burning
residues.
The manufacturer declines all responsibility for
any variations in the characteristics of the mate-
rial constituting the floor under the protection.
Set up an accessible technical space
for any maintenance work.
Remember to respect the minimum distance
from flammable materials (X), shown on the
identification plate of the pipes used to create
the chimney (Fig. 6).
Pi = Flammable wall
Pp = Floor protection
X1 = see annexed product manual
Pi
Pp
Set up the electricity supply line to arrive near the
appliance for the connection of the power cable.

5.4 Combustion air

The appliance, during its operation, requires
combustion air.
The inflow of combustion air can be obtained in
the following ways:
• coming directly from the outside with direct
connection to the combustion chamber (Fig.
7 - Fig. 8).
• coming from the installation environment or
from suitable adjacent rooms (Fig. 9)
FRANÇAIS ESPAÑOL
Pi
X1
Fig. 6
43