X-lite X-903 Sicherheit Und Gebrauchsanleitung Seite 16

X903
VISOR (XFS-03)
1 DISASSEMBLING THE VISOR
1.1 Open the visor completely (Fig.1).
1.2 Act simultaneously on both sides of the helmet, then use a finger to completely
push the release lever of the side mechanism downwards (Fig.2) and push the
visor away from the helmet using the finger (Fig.3).
2 ASSEMBLING THE VISOR
2.1 Position the left side part of the visor on the corresponding side mechanism so
that the pin inside the visor is magnetically attracted by the central seat of the
mechanism (Fig.4).
2.2 Rotate the visor up to its maximum opening position so that all internal side pins
fully enter into their seats and so that there occurs the click indicating complete
hooking of the left side of the visor to the mechanism (Fig.1).
2.3 Follow the previous operations on the right side of the helmet.
2.4 Slightly press both side parts of the visor to ensure that the automatic hooking fully
occurred.
2.5 Close the visor completely.
WARNING
- Make sure that the mechanisms are working properly. Open and close the visor,
making sure that the mechanisms hold it in the different positions. If necessary,
repeat the above-mentioned operations.
- Do not use the helmet if the visor has not been assembled properly.
Do not remove the side mechanisms from the shell.
-
- Should any of the side mechanisms fail or be damaged, please contact a Nolan-
group authorized dealer.
WARNING
The side mechanisms and the visor have some magnets: we recommend
that you read the specific warnings and precautions for use indicated in the
instructions label attached hereto.
(Available as standard or accessory/spare part)
1 ASSEMBLING THE PINLOCK
1.1 Disassemble the visor (see instructions above).
1.2 Ensure that the inner surface of the visor is clean and ensure that the pin adjust-
ment external levers are turned inwards (Fig.5).
1.3 Place the PINLOCK
The silicone-sealed profile of the PINLOCK
the inner surface of the visor.
1.4 Insert one side of the PINLOCK
in position (Fig.6).
16
INSTRUCTIONS FOR USE
INNER VISOR
®
inner visor on the visor.
®
inner visor onto one of the visor pins and hold it
®
inner visor must be in contact with
®