Ferm BGM1020 Bersetzung Der Originalbetriebsanleitung Seite 6

EN
• Switching the machine on
• Check that the switch is in the "OFF/0"
position before connecting the machine to the
power supply.
• Press the power switch into the " ON/1"
position to start your bench grinder.
• Always keep the power cord out of the way of
the tool's moving parts.
5. Maintenance
Make sure that the machine is not live
when carrying out maintenance work on
the motor.
This machine has been designed to operate over a
long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon
proper machine care and regular cleaning.
Troubleshooting
Should the machine fail to function correctly, a
number of possible causes and the appropriate
solutions are given below:
1. The electromotor becomes hot
• The motor has become overloaded.
• Give the motor a chance to cool down.
• The motor is defect.
• Please contact the service address on the
warranty card.
2. Machine switched on, but will not run
• Interruption in the mains connection.
• Check mains connection for fracture.
• The switch may be damaged.
• Please contact the service address on the
warranty card.
Repairs and servicing should only be
carried out by a qualified technician or
service firm.
Cleaning
Regularly clean the device's casing with a soft
cloth, preferably after each use. Keep the fan slits
free of dust and dirt. Remove stubborn dirt using
a soft cloth, dampened with soapy water. Do not
use solvents such as benzene, alcohol, ammonia,
etc, which might damage the plastic parts.
6
Lubrication
The device does not need any additional
lubrication.
Defects
If a defect appears due to a part wearing out,
please contact the service center on the warranty
card. At the end of these instructions there is
an exhaustive overview of the parts that can be
ordered.
Environment
To prevent damage during transport, the
appliance is delivered in a solid packaging which
consists largely of reusable material. Therefore
please make use of options for recycling the
packaging.
Damaged and/or disposed of electrical or
electronic devices must be dropped off at
recycling stations intended for that
purpose.
Only for EC countries
Do not dispose of power tools into domestic
waste. According to the European Guideline
2012/19/EU for Waste Electrical and Electronic
Equipment and its implementation into national
right, power tools that are no longer usable must
be collected separately and disposed of in an
environmentally friendly way.
Warranty
Read the warranty conditions on the separately
supplied warranty card.
The product and the user manual are subject to
change. Specifications can be changed without
further notice.