Trouble Shooting; Maintenance; Disposal; Product Label - Cedes TOF/Spot Installationsanleitung

TOF/Spot

13. Trouble shooting

Status
LED off
Object in the
safeguarded area and
LED dimmed red
No object in the
safeguarded area and
LED bright red
If the problem persists, please contact your local CEDES
representative (www.cedes.com).

14. Maintenance

Although the TOF/Spot does not need regular maintenance,
a periodical functional check is strongly recommended as
follows:
 Check the mounting position and detection area of the
sensor
 Clean the optical window with a soft towel and a little
soapy water
NOTICE
Damage to the optical window
 Never use
or mechanically abrasive towels or
highpressure water to clean the sensors.

15. Disposal

The TOF/Spot should only be replaced if a similar protection
device is installed. Disposal should be done using the
most up-to-date recycling technology according to local
regulations and laws. There are no harmful materials used
in the design and manufacture of the sensor. Traces of
such dangerous materials may be found in the electronic
components but not in the quantities that are harmful.
© CEDES | V 4.0
Action
 Check supply power
 Check electrical
connections
 Check distance setting
 Check alignment
 Check electrical
connections
 Check distance setting
 Check alignment
any solvents, cleaners

16. Product Label

Each TOF/Spot is labelled as below.
It contains following information:
Figure 25: Product label - TOF/Spot (standard version)
Lot No.:
yymmdd: year (2 digits), month, day
mmmmmmmm: manufacturing job number
eeeee: employee number responsible for final test
cccccc: incremental number
English
11