SOMFY animeo 6 AC KNX DRM Gebrauchsanweisung Seite 10

EN
Before installation, please read and follow these instructions. Incorrect installation may lead to serious
m
injury. Disconnect all power cables to be installed! Take precautions against unintentional switching on!
The product must be installed, maintained and dismounted by a skilled person according to the relevant regulation.
An all-pole mains switch shall be incorporated in the electrical installation of the building to provide simultaneous
separation of at least 3 mm for all phases from the supply.
SOMFY cannot accept any liability for defects and damage caused by failure to follow these instructions. Please
keep these instructions for future reference.
m The individual motor cables must be protected electrically according to the current carrying capacity of the
cables used.
SOMFY hereby declares that this product is in compliance with the essential requirements and other rele-
vant provisions of the European Directives applicable to the European Union. A declaration of conformity
is available at www.somfy.com/ce.
A
MOUNTING
[1] Needed space for the DIN-rail version
1. Mounted in a electrical cabinet
[2] DIN-rail mounted
1. Clip-on the device
2. Unclip the device
B
WIRING
[1] Wiring diagram
Two wires of identical diameter must be used in
order to daisy chain the KNX bus cable.
[2] Check the correct running direction of the end
pro ducts.
UP: All end products move upward ()
STOP: All end products stop ()
DOWN: All end products move downward ()
n To close window press UP, to open window
press DOWN
We care about our environment. Do not dispose of the appliance with usual household waste. Give it to an
approved collection point for recycling.
10/32
- animeo . Motor Controller 6 AC KNX DRM . Ref. 5151044B
C
CONFIGURATION
[1] Factory RESET
n When electronic motors are to be controlled
through this Motor Controller device it is mandatory
to configure the start-up delay time for electronic
motors in the parameter settings of the ETS.