Blumfeldt Flagranti Crystal View Bedienungsanleitung Seite 33

Connecting to a gas cylinder
• Use max. 13 kg gas cylinder. Please refer to your gas supplier for suitable
gas cylinder.
• Refer to your gas supplier for instructions on the use of your gas cylinder.
• Only change gas cylinders outdoors or in a well ventilated area away from
naked flames and any other source of ignition.
• The gas cylinder must always be used in an upright position.
• Close the appliance control knob by turning fully clockwise.
• Close the gas cylinder tap and then attach the regulator onto the gas
cylinder.
• Tighten all connections firmly and with a spanner where appropriate.
• The cylinder should be located on the cylinder base.
• Check for leaks at all joints using soapy water. If a leak is found, tighten the
joint and then re-test.
Securing a gas cylinder
1. Position a gas cylinder inside the
tank housing.
2. Stick cylinder restraint straps
together (see picture). The straps
must be in a proper tightness for
the gas cylinder.
Note: Take care that the cylinder
restraint straps DO NOT strain the
regulator assembly.
EN
33