AEG IKE41600KB Benutzerinformation Seite 9

edge, along the outer edge of the
glass ceramic. Loosely screw the
fixing plates into the correct holes in
the protection casing.
• Insert the first appliance into the
worktop cutout. Mount the
connection bar under the appliance
so that a half of its width is still visible
- it will support the next appliance.
• For the Teppan Yaki, loosely screw in
the fixing plates to the worktop from
below (at the front and the rear of the
appliance).
• Insert the next appliance into the
worktop cutout. Make sure that the
front edges of the appliances are on
the same level.
• Fix appliances other than Teppan Yaki
with the use of snap-in springs.
• At the end, tighten the screws of the
Teppan Yaki.
• Use silicone to seal the gaps between
the appliances and those between the
appliances and the worktop.
• Press the rubber shape firmly against
the glass ceramic and move it slowly
along the edges to squeeze out
excess silicone.
• Put some soapy water on the silicone
and smoothen out the edges with
your finger.
• Do not touch the silicone until it
hardens, it can last for about a day.
• Carefully remove the silicone
squeeze-out with a shaving razor.
• Clean the glass surface.
ENGLISH 9