AEG IKE41600KB Benutzerinformation Seite 16

16 www.aeg.com
8.1 What to do if...
Problem
You cannot activate or oper-
ate the hob.
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactivated.
The hob deactivates.
Residual heat indicator does
not come on.
There is no sound when you
touch the panel sensor
fields.
comes on.
The control bar blinks.
Possible cause
The hob is not connected to
an electrical supply or it is
connected incorrectly.
The fuse is blown.
You touched 2 or more sen-
sor fields at the same time.
There is water or fat stains
on the control panel.
You put something on one
or more sensor fields.
You put something on the
sensor field .
The zone is not hot because
it operated only for a short
time or the sensor is dam-
aged.
The sounds are deactivated.
Child Safety Device or Lock
operates.
There is no cookware on the
zone or the zone is not fully
covered.
The cookware is unsuitable.
The diameter of the bottom
of the cookware is too small
for the zone.
Remedy
Check if the hob is correctly
connected to the electrical
supply. Refer to the connec-
tion diagram.
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician.
Touch only one sensor field.
Clean the control panel.
Remove the object from the
sensor fields.
Remove the object from the
sensor field.
If the zone operated suffi-
ciently long to be hot, speak
to an Authorised Service
Centre.
Activate the sounds. Refer to
"Daily use".
Refer to "Daily use".
Put cookware on the zone so
that it fully covers the cook-
ing zone.
Use suitable cookware. Refer
to "Hints and tips".
Use cookware with correct
dimensions. Refer to "Tech-
nical data".