Stand-Alone Assembly; How To Prepare The Cable - Clarke-tech Flat-200 Twin HD-Ready Benutzerhandbuch

5) Stand-alone Assembly

Place the Joint Bracket A (B4) with its flat surface up as in figure (13).
Fix the 4 rubbers (E1) from the bottom.
Place the Body Bracket (B1) in the center of the Joint Bracket A (B4) and fixate it with screws (M2)
using B7.
Assemble the antenna (A1) as in Figure (14) by slipping the back of it into the Body Bracket (B1).
Fix A1 with screws (M4) & scratched nuts (M6). Do not tighten firmly the screw (M4) for you
may later need to calibrate the elevation angle while
searching the signal.
For stronger stability you can fix the set to the
table by screws (not provided).
Tighten firmly all the screws of the antenna once
you find a final position for the best signal quality.
E1
Flat-200 Twin HD-Ready
1. Prepare the cable.
12 mm
9 mm
11
B1
B4
E1
M2
Figure (13)

How to Prepare the Cable?

2. Give the hood of
insulation into the cable.
A1
M4
Figure (14)
3. Screw the slip "F"
to aid of one peg
if necessary.
M6
B1
B4
4. Slip "F" mounted.