Wall Mount Assembly; Window-Sill Mount Assembly - Clarke-tech Flat-200 Twin HD-Ready Benutzerhandbuch

3) Wall Mount Assembly

Attach the Joint Bracket (B5) perpendicularly to the wall with ankles & screws (not
provided) as in Figure (9).
Insert the whole antenna set previously assembled as in Basic Type Assembly above
and tighten it with 2 of M4s and the accompanying M6s as in Figure (9).
Make sure that B2 attached to the antenna is horizontally
placed and mount it with all the remaining M6s.
Tighten firmly all the screws of the antenna once you find
a final position for the best signal quality.
A1
M6
Figure (9)
M4

4) Window-sill Mount Assembly

Assemble the Window Slide Bracket (B6) and the Joint Bracket B (B5) with the screws (M1) as in
Figure (10-1). You will need a cross screwdriver. Do not tighten the screws too firmly.
Insert the whole antenna set previously assembled into B5 as in Figure (10-2), and tighten with 2 of
M4s & the accompanying M6s.
3 Slide the whole set into the space between your window and windowsill as in Figure (11). You may
adjust the width of B6 to the thickness of your windowsill. Then tighten securely with 4 of M1s
from the top using a screwdriver. Use the rest of M1s to firmly fix the whole set to the window in
the middle of B5 as in Figure (12).
For more support, attach the Window Support Bracket (B3) to the whole set as in Figure (12), by
fixing it to B2 with one of M4 & one of M6. B3 should be secured in order to support the whole
antenna set in a horizontal position. Adjust the position of B3 by sliding it into B2 to obtain the
best possible horizontal position of the whole antenna set.
Make sure that B2 attached to the antenna is horizontally placed and mount it with all the
remaining M6s.
Tighten firmly all the screws of the antenna once you find a final position for the best signal
9