Clarke-tech Flat-200 Twin HD-Ready Benutzerhandbuch Seite 20

Assemble the Body Bracket (B1): Attach B1 to the Support Bar (B2) with the screws (M2) &
(M3) as in Figure (3). Be sure to use spring & flat washers for M2 and M3, using the Spanner
(B7) for tightening. Do not tighten M2 & M3 too hard, because you may later need to calibrate
the azimuth angle for the signal search.
Assemble the Antenna Ass'y (A1) as in Figure (4): Slide the back of A1 into B1 . Fixate A1
withthe screws (M4) & the scratched nuts (M6). Again do not tighten the screw (M4) too hard,
for you may later need to calibrate the elevation angle for the signal search.
In case you would like to fix A1 facing your right-hand side, which is the opposite direction of
Figure (3) , you should turn B1 180 degree horizontally as in Figure (5) and fixate A1 as in
Figure (6). This may be necessary when your antenna should not protrude outside the balcony.
Tighten securely all the screws of the antenna once you find a final position for the best signal
quality.
B1
M3
Figure (3)
M2
M3
Figure (5)
7
M2
B2
B1
B2
A1
M6
B1
M4
Figure (4)
A1
M6
B2
M4
Figure (6)
B2