Basic Operation - Block Cvr 100 Bedienungsanleitung

Basic operation

Setup
› You will be asked if "Setup Wizard" is to be started, when the device is switch to IR/MEDIA/DAB/FM
for first time. If you don't want this to be installed or it is to be started at a later point in time, you
will be able to start this setup function again as follows:
MENU › System settings › Setup Wizard
The following will occur, if the „S etup Wizard" is carried out:
› You can select the desired time format (12/24 hour display).
› Whether and which source is to carry out automatic updates.
› Your time zone (Germany has the time zone +01:00)
› Set the daylight savings options ON/OFF
› Set the W-LAN region (Germany is „M ost of Europe")
FM /DAB operation
› Press the „SOURCE" button repeatedly or select „Radio Operation" in the main menu for FM/DAB radio
operation.
Stations
Setting stations
For FM
› Press the „TUNE +/–", „ENTER", the „CONTROL" dial or press the „
ger to start an automatic station search. The search function will stop, once a station has been
found. You can improve the frequency gradually in 0.05 MHz steps by pressing the „ " and „ "
buttons down shortly or by turning the „CONTROL" dial.
For DAB
› Press the „TUNE +/–",
If no stations in the list, the unit will auto active full scan function to search DAB stations.
Press menu key and go to DAB menu items to select full scan or Manual scan to search DAB stations.
› You can access and use additional settings in the radio menu. Press the „MENU " button.
Select the radio menu option in the main menu, if you have not already gained access to this
menu option.
Scan setting › Select this option to search and stop after a station with good reception has been
found.
Audio setting › Select this setting to play stations with weak signals in mono.
▲
or press the „ " and „
Chapter 5
Basic operation
" buttons to select stations in station list.
45
5
▲
" and „ " buttons down lon-
▲