Chapter 4 Connection; Power Supply; Antenna; Signal Output - Block Cvr 100 Bedienungsanleitung

-
4
Connection

Power supply

› Plug the power cable into a correctly installed power outlet of your public power system.

Antenna

› Connect the tuner antenna connector to the „Tuner Antenna" connection on the back of the device.

Signal output

› Connect these jacks to the respective jacks found on your amplifer. Ensure that connections
have been made properly (this normally means red to red and white to white).

Network

› A RJ45 cable is used to connect the LAN connection on the device to your router.

W-LAN

› For wireless operation, attach the antenna to the „Wi-Fi 2.4G Antenna" connection. Your pass-
word may be required for the wireless network.
Chapter 4
44
Connection