Detergent Drawer; Troubleshooting - ECG EWS 1063 DQD Bedienungsanleitung

Detergent drawer

The use of detergent can eventually lead to residues in the detergent
drawer. We recommend removing the drawer every 2 months and cleaning
up the accumulated residues.
Removal of the detergent drawer:
• Pull the drawer forward so that it is fully out.
• Carefully push on the drawer (see figure below) and pull it out.
• Clean the drawer with water and a soft brush.
• If there is any dirt left in the drawer, remove it with a soft brush. Make
sure that no residual dirt gets into the washing machine.
• Dry the drawer thoroughly and slide it back.
Do not wash the detergent drawer in the dishwasher.
•
Flushing plug / body / drum
Flushing plug
1.
Remove the detergent drawer and remove the flushing
plug. Thoroughly remove all residual softener. After
cleaning, replace the flushing plug and check that it is
fitted correctly.
Body
2.
Use a mild non-abrasive cleaner or soap and water to
clean the outer shell. Wipe dry with a soft cloth.
Drum
3.
Do not leave metal objects such as needles, paper clips, coins, etc. in the washing machine. These objects cause
rust to form on the drum. Use a chlorine-free cleaner and follow the detergent manufacturer's instructions to
clean the rust. Never use a scouring pad or similar hard objects to clean rust stains.

TROUBLESHOOTING

The washing machine should be repaired by an authorized service company. If the washing machine needs to
be repaired or if you cannot solve the problem using the instructions below, you should:
• Unplug the washing machine from power supply.
• Close the water supply.
ERROR
The washing machine
does not turn on.
20
POSSIBLE CAUSE
The washing machine is not
connected to electricity.
The fuses are defective.
There is no electricity.
The Start/Pause button was not
pressed.
The program selector is on "stop".
The door of the washing machine is
not closed.
Push down
Pull out
1
TROUBLESHOOTINGU
Connect the washing machine to
power supply.
Change the fuses.
Check the power supply.
Press Start/Pause
Switch the program selector to a
required position.
Close the washing machine door.