Electrical Chamber; Start-Up - Delta UV ELEKTRA UV Installations- Und Wartungsanleitung

D. ELECTRICAL CHAMBER
Ballast
4-pin connector
of the UV lamp
Quartz Guide
E. START-UP
Option :
Your Elektra UV unit is equipped with a safety pressure switch.
This one does not allow the UV bulb inside the unit to light unless there is at least 0,3 Bar (5
psi) operating pressure inside the chamber.
This is to ensure that the bulb will not create heat when the Elektra UV unit is empty or water is
not flowing in the wet chamber.
1 Start the circulation pump.
Drain all air from your system through the air relief valve on the filter (if so equipped).
2
Make one check for leaks in your piping, accessories, and under the electrical enclosure
3
bonnet.
Check the chemical balance of your swimming pool (particularly pH, TAC* et
TH*) and adjust them in function.
4
Reminder: Your Elektra UV does not eliminate the
need for proper pool chemical balance.
* TAC = Alcalimetric Titration (alkalinity of water)
* TH = Water Hardness
V5 Elektra E et ES Anglais.doc
Marque, Modèles et Brevets déposés - Produits exclusifs
UV Lamp
Mounting gland
Pressure switch
(option)
Copyright DELTA UV
Page 8