Transmitter Instructions - Velleman VM109 Handbuch

Transmitter instructions

The transmitter comes with a factory set default code. However, for security reasons, it might be wise not to use the default code.
1. Open the enclosure (see picture) :
2. To program your unique code :
Hold SW1(*) (left button).
Briefly press the 'program'-button (SW3) 3 times. The LED will flash 3 times.
Release SW1.
Your unique 32-bit code has been generated and stored.
(*If you hold SW2 (right button) instead of SW1 (left button), the unit will generate and store your unique 32-bit code and
the transmitter will be configured in such a way that continuous transmission is not possible i.e. if you hold either button
transmission will stop after a +/- 1s)
3. To return to the default code :
Hold SW1 (left button).
Hold the 'program'-button (SW3).
After +/- 10s the led will flash 5 times.
Release both buttons.
Your code has been erased.
SW1
SW3
Transmitter instructions
SW2
5