Maintenance And Safety; Malfunction And Excessive Strain; Heated Media - thermocoax Isopad IDR-G Serie Bedienungsanleitung

__________________________________________________________________________________

Maintenance and Safety

Maintenance and Safety is performed according
to the standards listed under "General Safety
Instructions" and
Instructions", the regulations of the employer's
liability insurance associations applicable to the
respective way of use, as well as other relevant
rules applying to the application. At least once
per year the function of the temperature
controlling and temperature limiting safety
device has to be checked and the surface and
supply line should be inspected for visible
damage.
Repair:
If Repairs, then only to be carried out
(in factory) by original manufacturer.
Rearrangement or variances of design can
influence the performance. Those actions
need to be carried out by the manufacturer!
Only original spare parts have to be
implemented and equipment authorized by
the manufacturer!
When returned, please always confirm
decontamination status in written form and
support this information directly with the
returned product.
If a decontamination form is required, then
please get in contact with us, where we will
support you.
Please refer to "Technical Data" within this
operation manual for full technical details
"Additional Safety

Malfunction and Excessive Strain

If it has been assumed that safe operation is no
longer possible, the installation must be
permanently shut down and secured against
being inadvertently put back into operation.
This is the case, if...
... the product shows visible signs of damages
... the product is not operating according to
specification
... the product is not operating at all (no visible
indication of reason)
... the product has been exposed to excessive
strain
... the admissible product limits are exceeded
(e.g. storage, transportation, operating
temperature)

Heated Media

The product must not be used to heat
explosive media or
explosive gases when heated. The product
must only be installed outside hazardous
locations. When setting the temperature of
the control and, if applicable, of the limiter,
the properties of the medium to be heated
have to be observed!
Attention!
During operation, the product can develop
temperatures, which may lead to burning
when touched. Therefore suitable personal
protection measures have to be taken into
consideration. When switched on, the product
must not be touched!
media developing
9 | P a g e - S e i t e