Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
__________________________________________________________________________________
ENGLISH
__________________________________________________________________________________
General Safety Instructions
ATTENTION!
This information needs to be considered during
handling and operation of products with the
following description:
ISOPAD Drum Heaters
in soft jacket version
Series IDR-G
These will be referred as "product" throughout
this manual for ease of context.
Please read the manual carefully ahead of use of
these products. Follow the declaration on the
type plate and the warning instructions at the
product.
Keep
this
appropriation! This manual needs to be held in
charge apparently. The products can be
operated only according to occupational health
and safety law, regional safety regulations and
instructions of the Accident Prevention &
Insurance Association.
Please take these advices as part of the
operating instructions of your QA-System
Handbook. Handle these advices also like a
manual. Never remove warning labels on the
product!
This
product
had
manufactured according to IEC 60519-1:2003
and IEC 60519-2:2003. Operation, installation,
supply and maintenance of the product need to
be realized in accordance with these standards!
ELECTRICAL EQUIPMENT!
manual
for
later
been
designed
and
These products represent electrical equipment!
To prevent from danger caused by electric
energy, an earth leakage current breaker (ELCB
or RCD) has to be installed for protection
purpose. This ELCB should represent a tripping
current of 30mA.
To guard against electric shock, the products
have to be maintained and services by
authorized staff and users only!
Protection Class
see "Technical Data"
The protective arrangement of Protection Class I
(protective earth) according to VDE 0100
(Germany) or to the relevant standards in your
country is to be taken into consideration within
the application for the product. Metallic
components coming in contact with the product
have to be incorporated in the protection
measures of Protection Class I (protective earth).
For details please refer to the standards VDE
0100 (Germany) or to the relevant standards in
your country!
IP-Rating
see "Technical Data"
Infiltration of water or chemical components
used for examinations, can lead to harmful
electric shock. After a complete drying the
product can be taken back into operation.
Products which show bare heating conductors
have been overheated and misused. This
equipment has to be set off operation and safely
stored to prevent from reuse. Reuse may lead to
personal injury and needs to be avoided!
Overheating of the product can be eliminated by
power reduction by implementing power
controllers between supply and application or
by temperature control.
DO NOT TOUCH!
Never touch surface of product during operation
or when ready for use! No needles or
4 |
P a g e - S e i t e
Werbung
Inhaltsverzeichnis
