Product Design - thermocoax Isopad IDR-G Serie Bedienungsanleitung

__________________________________________________________________________________
- Maintenance, connection and repair have to
be performed by trained, specialized and
qualified staff.
- Do not cross the product onto itself.
- Ensure good contact between the product
and the surface of the component to be
heated. Do not overlap.
- Do not use for any other purpose than
intended.
- Ensure that the drum has an open vent to
prevent pressure build up inside
- Do not use with materials that may react in
an unknown or potentially dangerous
manner when heated
- The surface to be heated should be free from
all burrs and sharp edges, weld spatter, rust,
oil, paint, etc.
- If spillage occurs, unplug the heater and
allow it to cooling. As soon as the heater is
cool, clean the area with a solvent suitable
for removing the substance. Do not allow the
material to bake onto the heater.
- Prior to each use, please check for suspected

Product Design

The products consist of resistance heating wires
which are embedded in polymer insulation
material. The outer layers can be of polymer and
glass-fiber fabric materials. Along the closure
line the products are equipped with Velcro-tape
for installation and fixation. The products are
designed with integrated thermostats to control
and maintain the heating power output. The
desired temperature can be regulated via an
external digital controller mounted onto the
surface of the product. The products are
equipped with power supply leads ready for
termination. It is important to determine the
right size of the product. It should be chosen so
it results in no overlapping or shortage when
installed. For your individual application or
product selection assistance please contact us.
(see last page for contact information)
Product example
damage on heater
6 | P a g e - S e i t e