Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
__________________________________________________________________________________
Installation
1. The product is placed or laid around the
drum to be heated and fastened using the
Velcro-tape.
2. The object surface has to be dry and clean
(grease free). It must not be coated!
3. Ensure that the product is not excessively
stressed or strained during installation.
4. When installing the product, make sure that
it is in close and even contact with the entire
surface of the object to be heated.
Contactless sections will lead to overheating,
lack
of
performance
destruction. When embedded in insulating
material the effects are even more likely to
occur.
5. The product must never overlap when it is
placed or laid, otherwise the incurring
inadmissible excess temperatures will defect
or destroy it.
6. The product must not be placed or laid over
sharp edges, corners or burrs. Non-
observance of this provision may lead to
damage of the product.
7. Ensure that the stated ingress protection (IP
rating) is suitable for the environment of use.
For example, fabric insulated products are of
low IP rating and should only be operated in
dry areas.
8. Never stick needles or sharp objects (or the
like) in the product!
9. The product should be protected against
mechanical damage by suitable coverings
(e.g. insulation and metal sheeting)
10. In case of additional safety matters a
temperature limiting device may be installed
to protect the application components from
damage.
To prevent danger an RCD or ELCB
needs to be installed!
Handling Information
11. Never lift or pull the heating unit by its power
cord or lead wire.
12. Never handle the heater while in operation.
13. When removing or maintaining the container
heater, disconnect the power and allow the
and
possible
heater to cool down to ambient before
handling.
Caution:
To avoid external touching and damage, it is
required that within the application the product
(component) has to be covered by a metal
sheeting or braid, which has to be included in
the protective arrangement of Protection Class I
(protective earth) according to VDE 0100 or to
the relevant standards in your country and is to
be taken into consideration.
Metallic components coming in contact with the
product have to be incorporated in the
protection measures of Protection
Class I (protective earth). For details please refer
to the standard VDE 0100 (Germany) or the
relevant standards in your country.
Additional
to
these
requirements for the specific products are found
on the product label or type plate and must be
followed as well.
The products are designed at a certain
protection class. Considering that the product is
not protected against hazardous body currents,
it has to be installed in such a manner that any
risk is excluded.
In case of doubt or if necessary please contact
us. (see last page for contact information)
Operation
Prior to connection of the product, please
ensure that the supply voltage matches the
product data label or the product specifications
out
of
the
accompanied
respectively.
Any product must be temperature
controlled! (unless otherwise stated or
specified)
Controller
To change the settings of the controller unit the
following steps should be considered:
instructions
special
documents,
7 |
P a g e - S e i t e
Werbung
Inhaltsverzeichnis
