Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
__________________________________________________________________________________
-
Maintenance, connection and repair
have to be performed by trained,
specialized and qualified staff.
-
Do not cross the product onto itself.
-
Ensure good contact between the
product and the surface of the
component to be heated. Do not
overlap.
-
Do not use for any other purpose than
intended.
-
Do not use with materials that may
react in an unknown or potentially
dangerous manner when heated
-
The surface to be heated should be
free from all burrs and sharp edges,
weld spatter, rust, oil, paint, etc.
-
Prior to each use, please check for
suspected damage on heater
Please follow the local guidelines for safe
installation of pressurized gas bottles:
Following the German technical guideline TRG
310 for safe use of pressurized vessels it is
stated that the maximum allowed operating
temperature may not exceed 50°C (122°F). It
is within the responsibility of the operator of
the equipment to follow the safe use
according to local guidelines.
Product Design
The products
consist of self-regulating
grounded
heating
embedded in polymer insulation material. The
outer layers can be of polymer and glass-fiber
fabric materials. Along the closure line the
products are equipped with Velcro-tape for
installation and fixation. The products are
equipped with power supply leads ready for
termination. It is important to determine the
right size of the product. It should be chosen so
it results in no overlapping or shortage when
installed. For your individual application or
product selection assistance please contact us.
(see last page for contact information)
elements
which
are
Installation
1. The product is placed or laid around the
gas bottle to be heated and fastened
using the Velcro-tape.
2. The object surface has to be dry and clean
(grease free). It must not be coated!
3. Ensure that the product is not excessively
stressed or strained during installation.
4. When installing the product, make sure
that it is in close and even contact with
the entire surface of the object to be
heated. Contactless sections will lead to
overheating, lack of performance and
possible destruction. When embedded in
insulating material the effects are even
more likely to occur.
5. The product must never overlap when it is
placed or laid, otherwise the incurring
inadmissible excess temperatures will
defect or destroy it.
6. The product must not be placed or laid
over sharp edges, corners or burrs.
Non-observance of this provision may lead
to damage of the product.
7. Ensure that the stated ingress protection
(IP rating) is suitable for the environment
of use. For example, fabric insulated
Product example
6 |
P a g e - S e i t e
Werbung
Inhaltsverzeichnis
