Philips BT5275 Bedienungsanleitung Seite 9

Note: The comb does not it on the trimming head when the 15mm (0.6in)
side is pointing towards the front of the appliance. If this is the case, turn the
trimming head before you slide the comb onto the trimming head.
2 Turn the zoom wheel to select a length setting.
- The length setting selected is the one right below the indicator on the
front of the appliance.
- You can select a length from 0.4mm to 10mm (see table in section
'Length settings' below).
3 Press the on/off button to switch on the appliance.
4 To trim your beard, move the comb through the hair slowly.
When you are inished, press the on/off button to switch off the
5
appliance.
Tips
- Always make sure that the tips of the comb point in the direction in
which you move the appliance.
Make sure that the lat part of the comb is always in full contact with
-
the skin to obtain an even hair length result.
- Since hair grows in different directions, you need to move the appliance
in different directions (upward, downward or across).
- Trimming is easier when skin and hair are dry.
English
9