Orbis ORUS Montage Seite 49

maintained until the end of the timing; operation will then switch to
automatic. If, during the timing, operation is switched to manual or off, the
timing ends.
Timed deactivation
If in off status you set a timing, such off status will be maintained until
the end of the timing; operation will then switch to the one active before
deactivation. If, during timing, the system is activated, the timing ends.
In all cases, the timing condition is signalled by the symbol "
Setting a timing
To activate timing it is necessary to
press the " " key
The writing "00h" will flash, indicating
the timing. With the "
keys it is possible to choose a value
between 0 and 99. Pressing the " " key
will allow to choose the measurement
unit between hours and days.
Each change in measurement unit
implies a resetting of the set timing value.
Once the value has been set, press " " to
confirm or wait 45 seconds.
Note. In case time is modified during timing, it will not be updated.
Note. In the hour count, the hour in which programming is carried
out is included. In the same way, if the measurement unit is in
days, the count also includes the current one. Timing in hours
terminate on the hour, the ones in days at midnight.
" and " "
- 47 -
Orus Programmable Thermostat User Manual
".