3-Channel-Mode: 1 X Stereo-System And 1 X Mono Subwoofer - Hifonics Vulcan Serie Benutzerhandbuch

VXi6404
X-OVER LP
MODE
LP HP FULL
30Hz
PROTECT
INPUT MODE
BASS LEVEL

3-channel-mode: 1 x Stereo-System and 1 x Mono Subwoofer

CONTROLLER
POWER
4CH 2CH
VXi6404
GND REM +12V
POWER INPUT
Loudspeaker Loudspeaker
left, front right, front
2 – 8 Ohms 2 – 8 Ohms
INTERCONNECTION
• Connect the RCA lineouts of the head unit with the RCA jacks LINE IN of the amplifier with appropriate high-value RCA cables.
If a separate SUB OUT from your head unit is available, use this for the LINE IN CH3/4 on the amplifier.
• Connect the speakers with SPEAKER OUTPUT + CH 1 - and + CH 2 -, and the subwoofer with the SPEAKER OUTPUT CH3/4
+ BRIDGED - of the amplifier.
• Always ensure that the total impedance load per channelpair (CH1 & CH2) is not lower than 2 ohms and the total impedance load
of the subwoofer (CH3 & CH4) is not lower than 4 ohms. Too low impedance cause high temperature and will shut down the
amplifier operation.
INPUT MODE SWITCH
• Refer to the notes on page 22.
CROSSOVER SETTINGS CH1/2 (STEREO SYSTEM)
• Refer to the notes on page 22.
LEVEL CONTROLLER CH1/2 (STEREO SYSTEM)
• Refer to the notes on page 22.
BASS BOOST CONTROLLER CH1/2 (STEREO SYSTEM)
• The BASS BOOST controller must be turned to 0 dB position in this interconnecting example .
CROSSOVER SETTINGS CH3/4 (SUBWOOFER)
• Refer to the notes on page 23.
LEVEL CONTROLLER CH3/4 (SUBWOOFER)
• Refer to the notes on page 23.
BASS BOOST CONTROLLER CH3/4 (SUBWOOFER)
• The BASS BOOST controller adjusts the bass enhancement between 0db and +12dB.
BASS REMOTE CH3/4 (SUBWOOFER)
• The enclosed BASS REMOTE CONTROLLER adjusts the bass-level e.g. from the driver's seat of the subwoofer on CH 3/4.
Please use only this enclosed bass remote controller and cable.
24
FUNCTIONAL INSTRUCTIONS
INTERCONNECTION EXAMPLE
CH3/4
LINE OUT
CH2 LINE IN CH4
BASS BOOST HP LEVEL
250Hz 0dB 12dB 10Hz 1.2kHz MIN MAX
4CH MONO MIX
X-OVER MODE
DUPE HP FULL
10Hz 1.2kHz MIN MAX
CH1 CH3
CH1/2
BRIDGED BRIDGED
FUSE
CH1 CH2 CH3 CH4
SPEAKER OUTPUT
Subwoofer 4 – 8 Ohms
VXi6404
LP HP or FULL
X-OVER
LP
MODE
LP HP FULL
30Hz 250Hz
PROTECT
INPUT MODE
BASS LEVEL
CONTROLLER POWER
4CH 2CH
VXi6404
4CH
GND REM +12V
Connect Bass
POWER INPUT
Level Controller
with the enclosed
cable
Connect stereo RCA outputs (FL/FR & RL/RR or
SUB OUT) of the head unit with LINE IN CH1 / CH2
and CH3 / CH4 of the amplifier
CH3/4
LINE OUT
LINE IN
CH2 CH4
BASS BOOST HP LEVEL
0dB 12dB 10Hz 1.2kHz MIN MAX
4CH MONO MIX
X-OVER MODE
DUPE HP FULL
10Hz 1.2kHz MIN MAX
CH1 CH3
CH1/2
BRIDGED BRIDGED
FUSE
CH1 CH2 CH3 CH4
SPEAKER OUTPUT