Very Important; Code Search - CME TOPTEL 2 GOLD Gebrauchsanweisung

located to your original remote control and enter these into
your TOPTEL 2 GOLD as described in point A.
ATTENTION ! if the model of your original remote con-
trol is not listed in the directory try and enter the other
codes which have been allocated to the same manufac-
turer.
If none of the codes entered give a positive result or you
don't know what code to enter, follow the procedure of
CODE SEARCH listed in point B.
A) PROGRAMMING THE CODE
1) Press and hold SET button and then press TV1 button.
Release the two buttons. The red light (LED) will start fla-
shing.
2) Enter in sequence the 4 digit code.
After the 4th digit a prolonged flash indicates the correct
insertion: if this does not happen try again.
In the same mode it is possible to enter 6 other apparatus
substituting the button TV1 with either one of the following
buttons TV2, SAT, VR1, VR2 or the buttons TV1-TV2 pres-
sed simultaneously will select TV3 and similarly VR1-VR2
pressed simultaneously will select AUX.
At this stage if you wish to control any one of the 7 appara-
tus entered, select pressing the relevant button, TV1, TV2,
SAT, VR1, VR2, (TV1+TV2 for TV3) and (VR1+VR2 for
AUX).

VERY IMPORTANT !

It can happen that you inadvertently press one of these but-
tons during the normal use and consequently think that your
TOPTEL 2 GOLD is defective, as it is not able to control the
equipment previously selected.
In this case, before any other action, select again this equip-
ment by pressing the relevant button (TV1, TV2, etc.).
We recommend that you take note in the table on page 1 the
numbers used for programming in case it may be necessary
to re-enter (for example changing used batteries).
B) CODE SEARCH
1) Switch on the equipment that you wish to control (if this
should be a VCR insert a cassette and manually select
the PLAY function).
2) Press and hold SET button and then press one of the se-
lection buttons (e.g. TV1 or VR1) which will associate with
the equipment you wish to command. Release the two
buttons. The red LED will start flashing.
3) Re-press the SET button and, after releasing it, point the
remote control towards the equipment pressing slowly
and repeatedly the OFF button (
and the STOP ( ) button in the case of the VCR, until the
equipment accepts the command i.e. the TV switches off
or the VCR stops to play.
We recommend a brief pause after each pressing action
of the button
has accepted your command.
4) When the equipment has accepted your command, press
the equipment button (e.g.TV1 or VR1) once again to me-
morize the code found.The red LED will flash twice.
Now try the other functions on your TOPTEL 2 GOLD to
ensure they all operate correctly.
If they do not all operate correctly, recommence the CODE
SEARCH from point 1) until a more accurate code is found.
As soon as the CODE SEARCH procedure is complete, we
recommend that you identify the codes found with the CODE
NUMBER IDENTIFICATION procedure listed in point C and
note them in the table on page 1 in order that they can be
easily re-entered if necessary, thus avoiding having to use
the search procedure again.
ATTENTION! THE CODE SEARCH CAN LAST FOR SE-
or in order to see if your equipment
13
) in the case of the TV