Gima N-126 Handbuch Seite 19

19
fig. 5
Connecting the Power Cord (fig. 7-9)
The cable and cords are vulnerable when bent or twisted, never subject the power cord to ex-
cessive force.
1. Set the main switch 1 to "0" (off) state before connecting the power cord.
2. Insert the plugs 2 into the power jack 3 of the microscope safely.
3. Plug the power cord 4 into the power supply receptacle 5. Make sure the connection is well.
• Do use the supplied power cord all the time. If lost or damaged, select the same standard cord,
please.
• A wide range of voltage, like 100V~240V, is acceptable for this microscope.
fig. 7
4
fig. 9
2
1
5
ENGLISH
fig. 6
fig. 8
Replacing the fuse (fig. 8-9)
Do remember to set the main switch 1 to the
state "0" (OFF) and unplug the power cord be-
fore replacing the fuse. Rotate the fuse out of the
holder 3, replace with a new fuse, then rotate it
back to the holder again.
3