Failure Codes And What To Do In Case Of Failure - Bauknecht GSFS 60002 A+ Gebrauchsanweisung

FAILURE CODES AND WHAT TO DO
IN CASE OF FAILURE
ERROR CODE
Wash Rinse Dry
If one of program monitor lights is on and start/Pause light is on and off,
Your machine's door is open, shut the door.
If the programme won't start
• Check if the plug is connected.
• Check your indoor fuses.
• Be sure that the water inlet tap is turned on.
• Be sure that you have closed the machine door.
• Be sure that you switched off the machine by pressing the Power On / Off button.
• Be sure that the water inlet filter and the machine filters are not clogged.
If the control lamps won't go out after a wash operation
The Power On/Off button is released yet.
If detergent residues are left in the detergent compartment
Detergent has been added when the detergent compartment was wet.
If water is left inside the machine at the end of the programme
• The water drain hose is clogged or twisted.
• The filters are clogged.
• The programme is not finished yet.
ERROR
Start /
DESCRIPTION
End
Pause
Inadequate water
supply
Error of continuous
water input
The waste water in
the machine cannot be
discharged.
Heater error
Alarm is active against
water overflow
Faulty electronic card
Overheating error
(temperature in the
machine is too high)
Faulty heater sensor
CONTROL
• Make sure the water input tap is totally open
and that there is no water cut.
• Close the water input tap, separate the
water input hose from the tap and clean the
filter at the connection end of the hose.
• Restart your machine, contact the service if
the error resumes.
• Close the tap.
• Contact the service.
• Water discharge hose is clogged.
• The filters of your machine might be clogged.
• Power off-on your machine and activate the
program cancellation command.
• If the error continues, contact the service.
Contact the service.
• Power off your machine and close the tap.
• Contact the service.
Contact the service.
Contact the service.
Contact the service.
43