Installing The Machine - Bauknecht GSFS 60002 A+ Gebrauchsanweisung

INSTALLING THE MACHINE

Positioning the machine
When determining the place to put your machine on, take care to choose a place where you can easily load
and unload your dishes.
Do not put your machine in any location where there is the probability for the room temperature to fall
below 0°C.
Before positioning, take the machine out of its packaging by following the warnings located on the package.
Position the machine close to a water tap or drain. You need to site your machine, taking into consideration
that its connections will not be altered once they are made.
Do not grip the machine by its door or panel in order to move it.
Take care to leave a certain clearance from all sides of the machine so that you can comfortably move it
back and forth during cleaning.
Make sure that the water inlet and outlet hoses do not get squeezed while positioning the machine.
Also, make sure that the machine does not stand on the electrical cable.
Adjust the machine's adjustable feet so that it can stand level and balanced. Proper positioning of the
machine ensures problem-free opening and closing of its door.
If the door of you machine does not close properly, check if the machine is stable on the floor it stands; if
not, adjust the adjustable feet and ensure its stable position.
Water connection
Be sure that the indoor plumbing is suitable for installing a dishwasher. Also, we recommend that you fit a
filter at the entrance of your place or apartment so as to avoid any damage to your machine because of any
contamination (sand, clay, rust etc.) that might be occasionally carried in through the mains water supply or
the indoor plumbing, and to forestall such complaints as yellowing and formation of deposits after washing.
Water inlet hose
Do not use the water inlet hose of your old machine, if any. Use the new water inlet hose supplied with
your machine instead. If you are going to connect a new or long-unused water inlet hose to your machine,
run water through it for a while before making the connection. Connect the water
inlet hose directly to the water inlet tap. The pressure supplied by the tap should be
at a minimum of 0.03 Mpa and and at a maximum of 1 Mpa. If the water pressure is
above 1 Mpa, a pressure-relief valve should be fitted inbetween.
After the connections are made, the tap should be turned on fully and checked for
water tightness.
For the safety of your machine, make sure to always turn off the water inlet tap after
each wash programme is finished.
NOTE: Aquastop water spout is used in some models. In case of using Aquastop, a
dangerous tension exists. Do not cut Aquastop water spout. Do not let it get folded
or twisted.
NOTE: The inlet water temperature varies according to the model installed.
Inlet hose marked: "25°C Max" up to a maximum of 25°C.
29