Bauknecht GSFS 60002 A+ Gebrauchsanweisung Seite 30

Water outlet hose
The water drain hose can be connected either directly to the water drain hole
or to the sink outlet spigot. Using a special bent pipe (if available), the water
can be drained directly into the sink via hooking the bent pipe over the edge
of the sink.
This connection should be at a minimum of 50 cm and and at a maximum of
110 cm from the floor plane.
Warning: When a drain hose longer than 4 m is used, the dishes might remain
dirty. In that case, our company will not accept responsibility.
Electrical connection
The earthed plug of your machine should be connected to an earthed outlet supplied by suitable voltage and
current. If there is no earthing installation, have a competent electrician carry out an earthing installation. In
case of usage without earthing installed, our company will not be responsible for any loss of usage that might
occur.
The indoor fuse current value should be 10-16 A.
Your machine is set according to 220-240 V. If the mains voltage in your location is 110 V, connect a
transformer of 110/220 V and 3000 W inbetween. The machine should not be plugged in during positioning.
Always use the coated plug supplied with your machine.
Running in low voltage will cause a decline in washing quality.
The machine's electrical cable should be replaced by an authorised service or an authorised electrician only.
Failure to do so may lead to accidents.
For safety purposes, always make sure to disconnect the plug when a wash programme is finished.
In order not to cause an electric shock, do not unplug when your hands are wet.
When disconnecting your machine from the mains supply, always pull from the plug. Never pull the cord
itself.
Fitting the machine undercounter
If you wish to fit your machine undercounter, check whether you have sufficient space under your
countertop and whether the wiring-plumbing is suitable to do so (1). If you decide that the space under the
countertop is suitable for fitting your machine, remove the worktop as shown in the illustration (2).
To remove the worktop, remove the screws that hold the worktop which are located at the rear of the
machine; then push the front panel 1 cm from the front side towards the rear and lift it.
30