Weber Protect ProV1 Bedienungsanleitung Seite 57

ProV1 - Mounting Instructions ProV1 - Mounting Instructions
The ProV1 can be mounted with or without the wedge-kits. The ProV1 can be mounted with or without the wedge-kits.
Follow the steps mentioned below to mount your ProV1: Follow the steps mentioned below to mount your ProV1:
1) Choose your preferred wedge kit, if you choose to use one. 1) Choose your preferred wedge kit, if you choose to use one.
2) (optional) Mount the Wedge Kit on the preferred location. 2) (optional) Mount the Wedge Kit on the preferred location.
(Drill 4 holes first, if you choose the Screw&Dowel mounting) (Drill 4 holes first, if you choose the Screw&Dowel mounting)
(Use the sticky pad, if you choose adhesive mounting) (Use the sticky pad, if you choose adhesive mounting)
3) 3) Place the mounting plate on the Wedge Kit or mount it directly onto Place the mounting plate on the Wedge Kit or mount it directly onto
the wall, if you choose not to use the wedge kit. the wall, if you choose not to use the wedge kit.
ProV1 - Hardwire Installation
Note/Warning:
your electricity before the hardwire installation
1)
Connect the small battery (250mAh) into
the bottom Connection-Slot.
2) (optional) Insert the SD-card.
3)
Connect the wires (green/yellow) into the
slot above the battery (see illustration).
Please make sure to turn off
to avoid injury!
57