Installation Of The Conex ® Dia-G - Grundfos Conex DIA-G Montage- Und Betriebsanleitung

9.6 Installation of the Conex
Warning
Switch off the power supply before
installing!
Enclosure class IP65 is only guaranteed if
the terminal covers are closed and the
appropriate cable glands or dummy caps
fitted.
1. Drill three holes (∅8 mm) as shown in the
diagram, and insert the supplied dowels.
2. Unscrew the terminal cover on the device.
3. Tighten the upper middle screw (A).
4. Place the device on this screw (A).
5. Secure the device through the enclosure using
the two other screws (B).
6. Replace the terminal cover.
Enclosure class IP65 is only guaranteed if
the terminal cover is correctly sealed!
Caution
Do not damage the terminal cover gasket!
The terminal cover gasket must fit exactly!
B
Fig. 6 Mounting drawing
18
®
DIA-G
A
Conex DIA-G
Sensor 1
Alarm
Sensor 2
Esc OK
B
99
10.5 198
Fig. 5 Drilling diagram of the Conex
®
DIA-G