Turning On And Off - Peiying PY-DVR030 Bedienungsanleitung

Rear camera:
Before installation, choose the correct place for mounting. Mounting
place has to be installed in a way, that it does not obstruct field of view.
Rear camera can be installed in two ways:
• On mounting tape. Peel off first piece of paper from the tape and stick
it to the camera's mounting bracket. Peel off second piece of paper
from the tape and stick the camera do selected place.
• On screws. Drill the holes in selected place and screw in the camera.
During drilling make sure, that no damage is done to any wire,
especially for safety systems.
After connecting the 2,5 mm plug to the AV socket in the dashcam, the
view from rear camera will appear in the top left corner of the display. If
red wire will be connected to the reversing lights (for example with quick
connector), after shifting into reverse gear, the view from rear camera will
be enlarged, helping the driver with maneuvering the vehicle. Note: for
this function to work, the red wire has to be connected to the same
electrical installation.
MicroSD card installation
1. Place the microSD card in the proper slot of the device and press
gently, until it clicks. Make sure, that the card is installed in correct
way.
2. To take out the card, press it gently. When the card slides out of the
slot, take it out.
Notes:
• The microSD card in the device will be treated as storage device. It is
advised to format it first.
• Use microSD cards with class 10 or higher, with maximum capacity of
32 GB.
EN

Turning on and off

1. To turn on the device:
• Press and hold the power button
• If the dashcam is connected to the cigarette lighter socket, the camera
will turn on automatically after ignition and start recording.
1. To turn off the device:
• Press and hold the power button
• If the camera is connected to the cigarette lighter socket, after turning
off the engine, the dashcam will turn off after 5 seconds.
12
Owner's manual