Configuring The Device - tell Gate Control PRO Schnell-Installationsanweisung

Gate Control PRO Quick guide
Registering the device identifier:
The device can be identified and accessed remotely based on. its unique device
identifier. You can read and copy the device ID to clipboard in the Status
monitoring menu.
You can store the device availabilities (name, device identifier, comments) using
the Add new
when you want to access the device remotely.
Remote access
- Launch the Gate Control programming software.
- Click on the Connection type menu and select the Cloud
- If you have already registered the availabilities of the device in the Device
register menu, select the device you want to connect to in the Device name
drop-down menu. Otherwise, enter the Device ID of the given device.
- Enter the Super admin (or Admin) User name and the remote access
Password configured for that.
- Click on the Connect
-> Chapter 4, 5.1.3, 5.2.1, 5.3.1 and 5.3.3 of the Installation and Application
Manual.

CONFIGURING THE DEVICE:

Configuring the inputs:
You can configure the default state (NO or NC) and the sensitivity of the inputs
in the Inputs menu.
For inputs IN1 and IN2 you can select a function. These two inputs can be used
to open the gate, or report doorbell activity or technical error via Push message.
You can enable gate position limit switches on inputs IN3 and IN4 by selecting
the Connected option. If you have one gate, you have to connect the position
limit switch to input IN3, while for 2 gates you have to use inputs IN3 (for gate
No.1) and IN4 (for gate No.2). After this, you can configure the Opening and
Closing timeout. If the gate fails to open or close within the configured interval,
the device will report a gate position limit error.
The device can be configured to send notifications via SMS, email or voice call,
when a contact input is triggered. You can configure the recipient phone numbers
and email addresses in the Reporting channels menu, and the input-triggered
notifications to these availabilities in the Input events menu.
button in the Device register menu, which will help you later,
:
button.
7
option.