Disposal Information; Before Using For The First Time - Bosch bsgl31466 Gebrauchsanweisung

de en

Disposal information

Packaging
The packaging is designed to protect the vacuum
cleaner from being damaged during transportation. It
is made of environmentally friendly materials and can
be recycled.
Dispose of packaging that is no longer required at an
appropriate recycling point.
Used vacuum cleaners
Used vacuum cleaners still contain many valuable
materials. Therefore, please take your used vacuum
cleaner to your retailer or recycling centre to be
recycled. For current disposal methods, please
enquire at your retailer or your local council.
Disposal of filters and dust bags
Filters and dust bags are made from environmentally
friendly materials.
As long as they do not contain substances that are
not permitted to be disposed of in the household
rubbish, you can dispose of them with your normal
household rubbish.
!
Please note
The mains socket must be protected by at least a 16
amp fuse.
If a fuse should blow when you switch on the
appliance, this may be because other electrical
appliances which have a high current draw are
connected to the same power circuit.
To prevent the fuse from blowing, select the lowest
power setting before switching the appliance on, and
increase the power only once it
is running.
Fold out picture pages.

Before using for the first time

1*
Figure
Open the dust bag compartment lid (see Fig. 23).
Remove the motor protection filter from the
appliance
Place the Bionic filter / AirFresh System onto the
motor protection filter.
Push the filter into the appliance and close the
dust bag compartment lid.
2*
Figure
Push the handle onto the flexible tube and until it
engages.
3*
Figure
Push the crevice nozzle and upholstery nozzle back
into the accessories holder as indicated.
Setting up
4
Figure
a)Push the flexible hose adapter into the air intake
opening on the vacuum cleaner lid until it engages.
b)To remove the flexible hose, press the two lugs
together and pull the tube out.
5*
Figure
a) Connect the handle and the telescopic tube together.
b)Push the handle into the telescopic tube until
it engages.
Press on the locking collar and pull out the
telescopic tube to disconnect.
6*
Figure
a) Connect the floor tool and the telescopic tube
together.
b)Push the telescopic tube into the connecting piece of
the floor tool until it engages.
Press on the locking collar and pull out the
telescopic tube to disconnect.
7*
Figure
To adjust the length of the telescopic tube, adjust
the adjusting sleeve/sliding switch in the direction of
the arrow and adjust the tube to the required length.
* Depending on equipment
9